Exporting Data - Huawei NetCol5000-A021 User Manual

NetCol5000-A021 In-row Air Cooled Smart Cooling
Product
User Manual (208 V)
If you perform this operation, all logs will be deleted, and device maintenance will be affected.
Exercise caution when doing this operation.
Procedure
Step 1 On the home screen, choose Maint > Log Maint > Delete Logs > Yes to delete all the logs.
----End

4.4.2.3 Exporting Data

Context
You can export data in one-click mode or by configurations. With the one-click mode, you
can export active alarms, historical alarms, run logs, and so on. The two export methods are
the same. This section uses one-click mode as an example to describe the export method.
You are advised to use the FAT32 USB flash drive with a capacity no greater than 64 GB.
Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus software
and is secure.
Procedure
Step 1 Tap Maint > USB Operations > Export to enter the Select Path screen, as shown in
4-27.
Issue 03 (2020-01-10)
After logs are deleted, the log deletion operation is recorded in the first log that is displayed.
 Before exporting active alarms, historical alarms, logs, and configurations, ensure that the USB flash
drive has been successfully identified. The position of the USB port is shown in

If the USB flash drive has been successfully identified,

If the USB flash drive is not properly connected, the system will notify that No USB device found.
during operations about the USB flash drive.
Copyright © Huawei Technologies Co., Ltd.
4 ACC Introduction
Figure 2-4.
is displayed at the status bar.
Figure
115