Table of Contents
Advertisement
NetCol5000-A021 In-row Air Cooled Smart Cooling
Product
User Manual (208 V)
In the teamwork iCooling mode, each micro module supports only one teamwork network,
and all smart cooling products must be networked in the teamwork mode. Smart cooling
products managed by different micro modules cannot be networked in teamwork mode. Smart
cooling products managed by each micro module must be connected to the EMS separately.
Assign teamwork group number and teamwork unit address for the teamwork controlled
smart cooling products as follows:
Context
The parameters in this section are for reference only. Set actually parameter values as
required.
Procedure
Step 1 On the home screen, tap
Figure 4-9 Teamwork settings
Step 2 Set teamwork control parameters.
You can set all the teamwork control parameters on the master smart cooling product but only
Teamwork group no., Teamwork unit address, and Teamwork function on a slave smart
cooling product.
Table 4-5 Teamwork settings
Parameter
Teamwork
Issue 03 (2020-01-10)
Teamwork group no.: Group the smart cooling products in adjacent areas as one, that is,
assign one teamwork control number for them. At most four teamwork control groups
can be assigned (1–4).
Teamwork unit address: The address for the smart cooling product in the same group
cannot be the same (address range: 1–32). The smart cooling product addressed 1 is the
master one that collects, processes, and delivers data. It is recommended that you set the
unit address numbers from one to the Total number of units in this group. Some
parameters of the slave units will be modified by the master unit synchronously.
Table 4-5
describes how to set the parameters.
Description
The number of the
teamwork controlled
Copyright © Huawei Technologies Co., Ltd.
> Teamwork Settings,
Configuration
Principle
Set the assigned
teamwork control
4 ACC Introduction
Figure 4-9
is displayed.
Default Value
1
97
Advertisement
Table of Contents
