Table of Contents
Advertisement
NetCol5000-A021 In-row Air Cooled Smart Cooling
Product
User Manual (208 V)
1.
2.
3.
4.
Step 5 Install the new filter dryer, as shown in
Weld the entrance elbow and the new filter dryer to form an assembly, and then weld the
assembly to the original position. Note that the arrow direction on the filter dryer identifies
the flow direction of the refrigerant.
Do not use face-down bonding.
Figure 6-11 Installing the filter dryer
1.
2.
3.
4.
Issue 03 (2020-01-10)
Remove the hold hoop from the filter dryer using a Phillips screwdriver.
Weld off the entrance elbow below the filter dryer.
Weld off the filter dryer assembly include filter dryer and entrance elbow from the above
of the filter dryer.
Weld off the entrance elbow from the filter dryer assembly and take out the filter dryer.
Remove the rubber plug sealing the port of the new filter dryer.
Weld the removed entrance elbow and the new filter dryer to form a new assembly.
Weld the assembly to the original position.
Secure the hold hoop in reverse order of removing it.
Copyright © Huawei Technologies Co., Ltd.
6 System Operation and Maintenance
Figure
6-11.
195
Advertisement
Table of Contents
