Mounting; Planning - Extron electronics TouchLink TLP Pro 525C Series User Manual

Mounting

This section outlines the various options for:
•
•
•
•
•
•
•
•
•
•
•

Planning

1.
2.
3.
4.
Planning
Tools Required for Installation
Included Parts
Ensuring Adequate Under-table Clearance for Retractors
Cutting the Table
Running Cables
Preparing MAAP or AAP Modules
Preparing Cable Pass-through Modules
Installing Modules
Mounting the Touchpanel Enclosure
Installing Cable Retractors (Optional)
Before making any cuts, select the best location for the touchpanel.
…
Ensure that the edge that opens on the lid is oriented correctly.
…
Ensure there is enough space for all the system cables and components, above and
below the table. Take account of:
Clearances for under-table cabling, especially if the cable has a large bend radius.
•
Adequate space below the table for cable retractors if they are to be installed (see
•
see Ensuring Adequate Under-table Clearance for Retractors
The number and type of AAPs required for the installation.
•
The location of devices that connect to the AAPs either above or below the table.
•
Verify that you have the correct template or dimensions (see
page 15).
Decide on the method for cutting a hole in the table (see
page 15). There are three methods available:
Hand router and guide
•
purchased separately.
CNC wood router
(see page 16) — must be programmed with the correct
•
dimensions.
Reciprocating saw or jigsaw
•
at www.extron.com).
The hand router used with the routing template or the CNC wood router are the most
accurate methods for cutting the hole. Either one of these methods is recommended by
Extron. The jigsaw is less accurate, but is also acceptable.
Check all relevant regulations.
… Ensure that the installation complies with local, state, and national building and electrical
codes.
…
Ensure that the installation complies with the Americans with Disabilities Act or other
accessibility requirements.
TLP Pro 525C and 725C Series Touchpanels • Mounting
Cutting the Surface
(see page 16) — requires a router template, which must be
(see page 16) — requires a paper template (available
on page 13).
Cut-out Dimensions on
on
11