Extron electronics TouchLink TLP Pro 525C Series User Manual page 20

5.
Run all cables to the touchpanel. These include Ethernet cable and cables for Retractors,
power modules, AAPs, and MAAPs (see
Leave enough slack to connect the cables before the enclosure is installed in the table.
6. Set up the touchpanels for network communication:
NOTE: If you use the setup menu to configure the touchpanel, configure the touchpanel
before mounting (see step 8, below) as you will need access to the
is under the table on the unit base.
… Connect an Ethernet cable to the touchpanels (see
… Connect the PC that you are using for setup, the Extron control processor, and the
touchpanel to the same Ethernet subnetwork.
… Use the Setup Menu
required, the IP address, subnet mask, gateway, and related settings for the touchpanel.
ATTENTION:
Do not power on the touchpanels or control processors until you have read the
•
Attention about Power over Ethernet (PoE) power supplies (see page 7).
Ne branchez pas les écrans tactiles ou les processeurs de contrôle avant d'avoir lu
•
la mise en garde
… Once the touchpanel is set up for network communication, disconnect the Ethernet
cable before installing modules and mounting the enclosure.
7. Prepare and install modules in the touchpanel enclosure (see
Modules on page 17, Preparing Cable Pass-through Modules on page
Installing Modules
on page 19).
If you are installing Retractors, install an empty bracket into the touchpanel and install the
Retractors after the enclosure is mounted.
8. Mount and cable the enclosure (see Mounting, starting on the next page).
9. Configure the TLP Pro touchpanels — the GUI Designer Help File, the Global Configurator
Help File, and the Toolbelt Help File provide step-by-step instructions and detailed
information.
The Global Configurator Help File also includes an introduction to that software and sections
on how to start a project and configuration.
Global Scripter provides an Extron-exclusive Python library (ControlScript) and
Global Scripter modules to get you started. See the GlobalScripter Help File for more
information.
TLP Pro 525C and 725C Series Touchpanels • Installation Overview
Running Cables
(see page 26) or Toolbelt to set the DHCP status and, if
sur les sources d'alimentation via Ethernet (PoE) (voir page 7).
on page 16).
button, which
Menu
Base Features on page 6).
Preparing MAAP or AAP
18, and
10