Figure 158 - Axial Bearing Removal; Figure 159 - Thrust Disk Removal - Danfoss Turbocor VTT Series Service Manual

Figure 158 - Axial Bearing
Removal
Figure 159 - Thrust Disk
Removal
124 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
12. Remove the three (3) M5x35 screws that secure the Thrust Disk and carefully slide the Thrust
Disk off the Compressor shaft.
All magnetic parts MUST be separated and placed in individual bags that can be sealed to
prevent contamination to the parts. Metal debris can and will lead to premature failure of the
Compressor components.
• • • CAUTION • • •
Axial Bearing
Screws - 30 Nm (22
ft.lb.) (4 places)
Axial Bearing
Assembly
Thrust Disk
Thrust Disc Screws
- 10 Nm (89 in.lb.)
(3 places)