Table of Contents
Advertisement
Figure 135 - First Stage
Impeller Removal
Figure 136 - Nylon Shaft
Protector and Cap
Compressor Components
24. Remove the "T"- Spacer.
25. Install a nylon shaft protector and cap over the end of the compressor shaft. Refer to the
Assembly Sleeve"
example in Appendix B. This is also shown in Figure 134 (Nylon Shaft Protector
and Cap).
Shaft Sleeve
"T" - Spacer
First Stage
Impeller Bolt
Shaft Cap
M-SV-VT-001-EN Rev. A
"Volute
109 of 165
Advertisement
Table of Contents
Need help?
Do you have a question about the Turbocor VTT Series and is the answer not in the manual?
Questions and answers