Figure 164 - Radial Bearing Assembly Removal; Figure 165 - Stator View - Danfoss Turbocor VTT Series Service Manual

Figure 164 - Radial Bearing
Assembly Removal

Figure 165 - Stator View

Stator Temperature
Sensor Connector
Compressor Components
17. Slowly tighten the four (4) jacking screws evenly, in a crisscross pattern. Continue this until the
Radial Bearing Assembly can be removed by hand.
18. While supporting the shaft, carefully slide out the Radial Bearing Assembly.
Do not allow the Radial Bearing Assembly to contact/rub the Compressor shaft during removal.
Damage to the shaft and or bearing assembly may occur.
19. Slide a small piece of Mylar underneath the shaft and gently lower the shaft onto the Stator.
20. Disconnect the internal Stator harness connector and test as described in the
Resistance Verification"
• • • CAUTION • • •
section of this manual.
"Stator Thermistor
M-SV-VT-001-EN Rev. A
127 of 165