Figure 111 - Pwm J11 Connector (Revisions C And Later); Figure 112 - Dc-Dc J2 Connector (Revisions C And Later) - Danfoss Turbocor VTT Series Service Manual

Figure 111 - PWM J11
Connector (Revisions C
and Later)
Figure 112 - DC-DC J2
Connector (Revisions C
and Later)
J2 Connector
Compressor Components
4. Remove the cable from the service side.
5. Open the panel containing the DC-DC.
6. Disconnect the 250 V (J2) connector from the DC-DC.
Installation (Revisions A and B):
1. Route the cable into the service side.
2. Secure the ground cable to the service side.
3. Insert the connector to J11 on the PWM Board.
4. Secure the cable where it enters the service side.
J11 Connector
M-SV-VT-001-EN Rev. A
95 of 165