Ccm-Cim 24V Cable; Removal And Installation; Figure 74 - Ccm-Cim 24V Cable (Revisions A And B); Figure 75 - Ccm-Cim 24V Cable (Revisions C And Later) - Danfoss Turbocor VTT Series Service Manual

Variable twin turbo compressors

Table of Contents

3.7.1.3 CCM-CIM 24V

Cable

Figure 74 - CCM-CIM

24V Cable (Revisions A

and B)

Figure 75 - CCM-CIM

24V Cable (Revisions C

and Later)

3.7.1.3.1 Removal and

Installation

Figure 76 - CCM J7

Connector (Revisions A

and B)

Figure 77 - CCM J7

Connector (Revisions C

and Later)

Compressor Components

The CCM-CIM 24V Cable passes 24V DC from the CCM to the CIM.

Removal:

1. Isolate the Compressor and VFD power as described in the

Compressor/VFD"

section of this manual.

2. Remove the Service Side Cover.

3. Locate J7 on the CCM Board and unplug the connector.

"Electrical Isolation of the

M-SV-VT-001-EN Rev. A

77 of 165

Table of Contents

Need help?

Do you have a question about the Turbocor VTT Series and is the answer not in the manual?