Figure 83 - J16 (Revisions C And Later); Figure 84 - J4 (Revisions C And Later) - Danfoss Turbocor VTT Series Service Manual

Figure 83 - J16
(Revisions C and Later)
J16 Connector
Figure 84 - J4
(Revisions C and
Later)
80 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
Removal (Revisions C and Later):
1. Isolate the Compressor and VFD power as described in the
Compressor/VFD" section of this manual.
2. Remove the Service Side Cover.
3. Disconnect the J16 connector from the CCM Board.
4. Remove J4 from the DC-DC Board.
J4 Connector
5. Remove the cable between the CCM and the DC-DC.
"Electrical Isolation of the