Table of Contents
Advertisement
Figure 109 - PWM J11
Connector (Revisions A
and B)
Figure 110 - DC-DC J2 and
J6 Connector (Revisions A
and B)
J2 Connector
J6 Connector
94 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
4. Remove the 250V PWM ground wire from the service side.
5. Remove the cable from the service side.
6. Open the panel containing the DC-DC.
7. Disconnect the 250 V (J2) clip from DC-DC.
8. Disconnect the 250V DC-DC ground wire from the DC-DC.
9. Remove the cable from the DC-DC panel.
Removal (Revisions C and Later Cables):
1. Isolate the Compressor and VFD power as described in the
Compressor/VFD"
section of this manual.
2. Remove the Service Side Cover.
3. Disconnect the J11 connector from the PWM.
J11 Connector
"Electrical Isolation of the
Advertisement
Table of Contents
Need help?
Do you have a question about the Turbocor VTT Series and is the answer not in the manual?
Questions and answers