Table of Contents
Advertisement
Figure 30 - Pressure/
Temperature Sensor Harness
Retaining Clips
P/T Sensor Harness
Retaining Clip
40 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
Installation Instructions:
1. Plug the cable harness connector into the suction sensor and discharge sensor.
2. Route the Pressure/Temperature cable to the service side and attach it to the Compressor
mounting brackets.
3. Plug the cable harness connector into J8 on the CCM.
4. Replace the Service Side Cover.
5. Restore power to the Compressor.
P/T Sensor Harness
Retaining Clip
P/T Sensor Harness
Retaining Clip
Advertisement
Table of Contents
Need help?
Do you have a question about the Turbocor VTT Series and is the answer not in the manual?
Questions and answers