Figure 61 - Rear Bearing Sensor Feed Through - Danfoss Turbocor VTT Series Service Manual

Figure 61 - Rear Bearing
Sensor Feed Through
Compressor Components
Stator Cooling Temperature Sensor Resistance Verification
There is a Stator Cooling Temperature Sensor located in the rear of the Compressor. It is mounted to
the Radial Bearing Assembly. This sensor contains a single circuit. Refer to Figure 160 (Stator Cooling
Temperature Sensor) for details on the exact location of this sensor.
1. Isolate the Compressor power as described in the
section of this manual.
2. Disconnect the external bearing sensor cable from the feed through. Refer to Figure 61 (Rear
Bearing Sensor Feed Through) for details on the location.
Rear Bearing Sensor
Feed Through
3. Use a multimeter set to resistance, verify the resistance of the circuit at the feed through.
Resistance should be measured between Pins 10 and 11and the measured value should be
within ± 10% of the resistance values listed in the chart in Table 20 (Stator Thermistor R/T Curve).
4. If the value is out of tolerance, the sensor will need to be tested internally. If the sensor is still not
within tolerance, it will need to be replaced. Refer to the
how to access the internal Rear Bearing Sensor connector.
5. Restore power to the Compressor.
"Electrical Isolation of the Compressor/VFD"
"Rear Bearings" section for details on
M-SV-VT-001-EN Rev. A
67 of 165