Table of Contents
Advertisement
Figure 102 - Feed Through
Connector
3.7.1.9 Motor
Temperature Sensor
Cable
Figure 103 - Motor
Temperature Sensor Cable
3.7.1.9.1 Removal and
Installation
90 of 165
M-SV-VT-001-EN Rev. A
Compressor Components
The motor temp sensor cable connects the motor temperature sensor to the CCM.
Removal:
1. Isolate the Compressor power as described in the
section of this manual.
2. Remove the Service Side Cover.
3. Locate and remove the connector from MOT RTD (J12) located on the top-left corner of the CCM
Board.
5
7
8
6
4
11
3
10
9
2
1
"Electrical Isolation of the Compressor/VFD"
Advertisement
Table of Contents
Need help?
Do you have a question about the Turbocor VTT Series and is the answer not in the manual?
Questions and answers