Table of Contents
Advertisement
To adjust azimuth, refer to
Loosen the two bolts on the pole collar.
4. Move the unit to either side, in small increments, as necessary to get the
optimum signal strength as shown on the voltmeter or by the fast high pitch
sounds that you hear with the headphones.
When you have maximized the signal quality:
5. Tighten the two bolts in the curved slots on the azimuth elevation bracket to
lock down the elevation adjustment.
6. Be careful not to change the unit's orientation while tightening the bolts.
7. Tighten the two bolts on the pole collar to lock down the azimuth adjustment.
8. Make sure all other fasteners on both brackets are tight.
Figure 46: Adjusting azimuth
Figure 46
Chapter 4 • Installation instructions
3500834-0001 Revision C
65
Advertisement
Table of Contents
