Table of Contents
Advertisement
IP Address/DHCP Settings
The IP settings page under the Settings tab includes the following fields:
• Terminal Local IP address
— Allows you to change the UT's IP address
— In PPPoE mode with the Inmarsat NSD you typically set the UT IP address
to 192.168.0.1. If two BGAN terminals are connected to the NSD, set the IP
address of the second UT to 192.168.0.129.
• Subnet Mask Range (release 5.9.5.3)
— Only used in PPPoE mode. If two BGAN terminals are connected to the
NSD, set to 255.255.255.128
• Default route IP address (release 5.9.5.3)
— Only used in PPPoE mode. Use with the NSD when the TE local subnet is
different from the UT subnet.
• DHCP Server enable
• DHCP Address Range
• Lease Time when Idle
• Lease Time when Connected
— If operating with a Vodafone MachineLink, recommend setting to a large
value such as 1440 minutes, or use Static addressing.
• Network Mode field: NAT, NAPT, Relay or PPPoE mode (see Network mode
section.)
• Relay Connected Mode Subnet Mask (release 5.9.5.3)
— Defaults to 255.255.0.0. Can be used to configure a different subnet mask
in Relay mode. Only applied when the Relay mode PDP context is active.
Figure 17: IP Address/DHCP Settings
Chapter 2 • Configuration via Web UI
3500834-0001 Revision C
31
Advertisement
Table of Contents
