Pointing The Terminal - EchoStar HUGHES inmarsat 9502 User Manual

Atex and ci/d2 compliant terminal with integrated antenna
Hide thumbs Also See for HUGHES inmarsat 9502:
Table of Contents

Advertisement

Pointing the terminal

Determine the azimuth and elevation for the look angle to the satellite in advance
of the installation by using the approximate latitude and longitude of the site in a
simple satellite pointing application or specially marked map. This is the preferred
mode as it simplifies the install and may be critical data for choosing the site if there
are multiple potential locations to mount the UT in wooded, mountainous or
built-up areas.
Alternatively, you can get the azimuth and elevation angle by powering up the UT,
allowing it to get a GPS fix and then checking the pointing information on the
9502 home Web UI page.
In order to speed up getting the initial GPS fix, while you are in pointing mode you
should lay the unit flat with a clear view of the sky first so that it can see as many
GPS satellites as quickly as possible. Once you get the initial GPS fix (GPS LED solid
green), then you can point the unit to the Inmarsat satellite.
If you short press the function button to enter pointing mode, all three LEDs start to
blink, indicating that the terminal is in pointing mode.
To aid in pointing, you can use two different methods:
You can also monitor the signal strength by hooking up a laptop/PC to the USB port
and monitor it from the Web UI (see
browser and typing in the local IP address of the terminal 192.168.128.100.
1. You can use the 3.5mm jack to connect stereo speakers or a headset in order
to hear the tones for pointing. As the signal strength increases, the tone pitch
will get higher and faster.
2. You can also use the 3.5mm jack to connect a 3.5mm stereo plug that has two
bare wires exposed. Measure the DC voltage between the two exposed wires
with a voltmeter while you are pointing. The range is 2.5V to 3.2V and the
higher the voltage the better the antenna is pointed. A reading of 3.0V
equates to a signal level of about 51dB, so try to get as close to 3.2V as
possible.
Figure
43). Access the Web UI by opening a
Chapter 4 • Installation instructions
3500834-0001 Revision C
61

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hughes 9502

Table of Contents