Table of Contents
Advertisement
M2M page
Chapter 2 • Configuration via Web UI
36
3500834-0001 Revision C
Figure 22: M2M Setup
The M2M page includes the following configurable parameters:
Ping Configuration
• Context Watchdog - On/Off. The watchdog can be used to periodically verify
the UT network connectivity and take recovery action if a problem is
detected.
• Primary Ping Address – enter an address pingable by the UT over the spacelink.
• Secondary Ping Address. If you don't have a secondary address, you can
configure the primary address in this field to give the UT more attempts to
reach the server.
• Tertiary Ping Address
• Time between Pings. If the connected device sends or receives data on a
periodic basis, set this time to be longer than the periodicity of the data.
• Ping required - Yes/No. If set to "No", the system will not try to ping on timer
expiration if data was transmitted within the watchdog period. This is the
recommended setting. If set to "Yes", the system will always ping when the
"Time between Pings" expires, which will cause extra data to be sent on the
link.
Advertisement
Table of Contents
