Table of Contents
Advertisement
Terminal installation using the basic fix mount kit
(P/N 3004066-0002)
The pole is shipped attached to the base bracket. Mount the base bracket of this
assembly to the structure with the appropriate hardware (not included). Consult
local building codes if needed. Once the base bracket is mounted, perform the
following steps (refer to
You may install the fixed mount on any structurally sound surface; either on a
horizontal, or vertical, or a sloped surface such as a roof or wall.
1. The pole has a 1.66" (4.2164cm) outer diameter (schedule 40 metal).
2. The pole mount is 2lbs/0.9Kg. The azimuth/elevation bracket is 1 lb/0.45Kg.
3. The wall mounting pattern has four bolts in a 6" x 3 ¾" (15.24cm x 9.525cm)
rectangle (not included). The holes are 0.325" diameter. See
Figure 29: Base bracket hole pattern
Figure 30
1. Insert the bubble level into the end of the pole (pipe) opposite the base
bracket. The bubble level fits inside the pole.
and
Figure
31):
Chapter 4 • Installation instructions
3500834-0001 Revision C
Figure
29.
51
Advertisement
Table of Contents
