Table of Contents
Advertisement
Automatic Contexts
This web page allows you to use Automatic Context Activation (ACA) for multiple
devices. (The M2M page Always on context can be used if you only require a single
context.) The ACA page is not available in NAPT or PPPoE modes.
Static IP Automatic Contexts: You can define static ACA entries for specific
addresses. If an entry is set to "On", the UT will set up a context for this address at
startup, regardless of whether it sees it. If set to "Data", the UT will activate the
context when it sees data from the device destined to the space link.
If the context is deactivated by the network, e.g. due to inactivity, the UT will
reactivate it.
To turn on ACA for a particular static address, select "On" or "Data" from the drop
down list and enter an address.
When you are finished, click on Update Static Settings and you should see a
message saying "Operation Successful".
Figure 13: Automatic Contexts
Chapter 2 • Configuration via Web UI
27
3500834-0001 Revision C
Advertisement
Table of Contents
