Mounting the azimuth elevation bracket
Chapter 4 • Installation instructions
52
3500834-0001 Revision C
2. Loosen the pole attachment fasteners at the base bracket so the pole can
swivel.
3. Swivel the pole until the end of the pole where the unit will be installed is
vertical. Adjust the pipe position until the bubble is centered inside the circles
on the top surface of the bubble level.
4. Tighten the pole attachment fasteners on the base bracket.
Figure 30: Base bracket and bubble level
Mount the azimuth elevation bracket to the back of the unit using four washers/nuts
(see
Figure
32). The holes on the back of the 9502 housing are in a 7cm (2.76") by
9cm (3.54") rectangular pattern. The nuts are ¼"-20 x 3/8".
Figure 32: Azimuth elevation bracket
Figure 31: Pole assembly