Table of Contents
Advertisement
Adjusting the azimuth and elevation of the terminal
Chapter 4 • Installation instructions
64
3500834-0001 Revision C
Important Notes:
•
To aid in pointing the unit, there is a 3.5mm stereo audio jack port on the
9502. The user can insert a stereo headset to hear audio tones or use a
voltmeter to measure the voltage which indicates the quality of the signal
detected during install mode.
•
The unit must have DC power applied for pointing.
•
The GPS antenna is an integral part of the unit and a GPS fix can be
obtained as part of the pointing process.
•
Once you are out of pointing mode, you need to stay away from the front
and sides of the unit at least 1m for safety purposes.
To adjust elevation, refer to
1. Loosen the two bolts in the curved slots on the azimuth elevation bracket.
2. Read the elevation angle from the elevation scale on the bracket, using the
red edge on the pole collar as the angle indicator. View this edge through the
curved slot on the azimuth elevation bracket.
3. Pivot the unit to obtain the desired elevation.
Figure 45
Figure 45: Adjusting elevation
Advertisement
Table of Contents
