With the introduction of MEAS, there are now parts of the overlap areas of
MEAS and EMEA, such as the yellow shaded area below, where the antenna
might be able to see a second satellite.
Figure 41: Area where the UT may see 2 satellites
During site switches, the satellite signal is turned off briefly and the UT may try to
register on the other satellite it can see. The signal will be weaker and will degrade
service so it is advisable to select operation on a single satellite.
The visible satellites are shown on the status bar of the Home page. To configure the
UT to use a single satellite, use the
higher. Alternatively, use the _IHSET="SAT_SELECT" remote control SMS to configure
the satellite.
General Setup
page (30) in release 5.9.5.0 and
Chapter 4 • Installation instructions
3500834-0001 Revision C
59