Advanjet Software; Installing And Starting Up The Software - Graco Advanjet Diaphragm-Jet HV-2000 Setup And Operation

5. Advanjet Software

The Advanjet software is not required if the controller will always be operated from the
front panel keys. However, if a PC user interface is preferred, or if access to the
controller front panel keys is limited, the Advanjet Software provides the option of
programming the jetting parameters from a PC using Windows XP, Vista, Windows 7,
and Windows 8.
5.1

Installing and Starting Up the Software

1. Insert the installation CD or obtain a link to download the Advanjet controller
program from
installation instructions.
2. Once the software is installed, connect the RS-232 cable from the PC to the
HV-2000C controller, connect the pneumatics as shown in Figure 2-1, and
connect jet cable to the controller. Turn on the controller and set the Jet Pressure
to 40 psi (0.28 MPa).
3. Start the Advanjet software by clicking on the Advanjet2000 entry in the Start
Programs menu. (A shortcut for this program can be created.)
4. On startup, the Advanjet Software program will poll the HV-2000C controller and
automatically establish the RS-232C port and connection. A ―Failed to find COM
port for Advanjet Controller‖ message will appear if the program cannot establish
communication with the controller. If this message appears, check the RS-232
cable for proper connection between the PC (see Section 4).
The Settings menu appears as shown below. Check that the Jet button [1] is Red and
that the Controller Status [11] indicates ―Ready.‖ The Advanjet program is ready.
[ 10 ]
RS-232
SETTINGS
[ 1 ]
VALVE STATUS
[ 6 ]
TRIGGER MAP
[ 7 ]
DOWNLOAD
SETTINGS
RECIPES [ 2 ]
[ 11 ]
CONTROLLER
STATUS
3A5856A
www.Advanjet.com.
Figure 5-1: Advanjet Software Settings Menu
Advanjet HV-2000C Jet Controller Setup and Operation
Run Advanjet2000_Installer.exe and follow the
[ 8 ]
HEATER OPTIONS
[ 9 ]
HEATER OFF TIMER
[ 3 ] COUNT
[ 4 ] TRIGGER MODE
[ 5 ] GO
[ 11 ]
CHECK
CONTROLLER
BUTTON
Page 21 of 60