Transfer - Ricoh 1000L Field Service Manual

6-7 TRANSFER

6-7-1 Transfer Corona Unit
1. Open the upper unit.
2. Take out the master unit (do not touch the master belt).
3. Remove the terminal block (A) — 2 screws.
4. Remove the front endblock securing bracket (B) – 1
screw.
5. Remove the rear endblock securing tab (C) — 1 screw.
6. Remove the transport guide plate (see page 6-35) – 4
screws (one has a ground wire).
To remove this guide plate, you will need to push the
transfer corona unit towards the development unit.
7. Carefully disconnect the corona power supply harness (D)
at the power pack (use long-nosed pliers).
8. Remove the transfer corona unit (E).
6 - 20