How To Extend The Stretcher; Lifting Handles; Lateral Holes; Pins - Ferno SCOOP EXL Stretcher User And Maintenance Manual

Stretcher configuration

4.4 How to extend the stretcher

In the event that the stretcher is folded (foot section over the body section, Figure 9), follow these steps to extend the stretcher:
1. Place the stretcher on a flat surface.
2. Lift the foot section and place it on the same surface as the body section.
3. Release the locking levers so they are facing up (see section 4.1 "Length adjustment", page 9).
4. Adjust the length of the stretcher and lock it in the desired position (to correctly adjust the length of the stretcher see Section
4.1 "Length adjustment", page 9).

4.5 Lifting handles

The stretcher is equipped with four lifting handles at the
head end and the foot end.
Grasp the lifting handles to lift the stretcher (Figure 11).
Lift only the weight that you can safely support. Use
additional help when working with heavy loads (see Section
5.7 "Additional help", page 26).
4.6 Side holes
The stretcher is equipped with:
2 small lateral holes for fastening the "H"-shaped
●
Velcro band of the 365-E head immobilizer. The small
holes are provided only at the head end of the stretcher
(Figure 12).
8 side handles (4 per side). Each handle has a pin
●
inside for attaching restraint hooks (Figure 13).
4.7 Pin
The stretcher is equipped with 8 pins for attaching restraint
hooks. The pins are present in the side holes of the stretcher
(Figure 13).
12
Foot end
handles
Figure 11 - Lifting handles
Side holes
Figure 12 - Small side holes for "H"-shaped head
immobilizer
Figure 13 - Side holes with pin
© Ferno Washington Italia ScoopExl - Rel.161115 - ENG
SCOOP EXL Stretcher
Head-end
handles

Pins