Data Functions; Saving The Memory Card Parameter Settings - Siemens SINAMICS S120 Manual

Options
9.19 K90, Control Unit CU320-2 DP
STARTER setup is possible with native Windows versions with Asian languages only if the
Windows XP or Windows 7 software is an MUI version.
Acrobat Reader V5.0 or higher is required to open the function diagrams in the online help.
Note
Preconditions in conjunction with STEP7
If STARTER is used in combination with other STEP7 components, the prerequisites for the
S7 components shall apply.
Additional system requirements for installing a CompactFlash card reader
● Free USB connection
● CD-ROM drive (for installing the driver for the card reader)
9.19.10.2

Data functions

Once a card reader has been connected and successfully installed, the data on the memory
card can be accessed in the same way as data stored on other PC storage media (e.g.
access to hard disk, memory stick, etc.). To access its data, the memory card must first be
removed from the CU320-2 Control Unit and inserted in the card reader connected to the
PC.
The actual procedure for accessing the memory card data depends on the operating system
used.
9.19.10.3

Saving the memory card parameter settings

Following commissioning, it is advisable to back up the data on the memory card to an
external storage medium (hard disk, data carrier, etc.).
To do this, the memory card is read out via a card reader connected to a PC. Ensure that all
the files and directories are stored in the same form as on the memory card.
If necessary, the device status following commissioning of the drive can be restored by
uploading the saved data to the memory card.
Note
Possible plant standstill by withdrawing or inserting the memory card in operation
If the memory card is withdrawn or inserted during operation, then data can be lost, possibly
resulting in a plant standstill.
• Only withdraw and insert the memory card when the Control Unit is in a no-voltage
condition.
356
Cabinet Modules liquid cooled
Manual, 10/2015, A5E37067587A