Cable Routing For Motor Modules - Siemens SINAMICS S120 Manual

Electrical installation
4.5 Connections
1. Route the DRIVE-CLiQ/signal cable to the Control Unit into the cabinet from the bottom
left.
2. Use cable ties to secure the cable at suitable points.
3. Route the cable further in the cabinet to the upper side of the Control Unit. When doing
so, route the cable in a similar manner to the standard cables that have already been
installed in the cabinet.
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ/signal cable to the Control Unit.
6. Route the DRIVE-CLiQ/signal cable to the Active Line Module from the bottom left into
the cabinet.
7. Use cable ties to secure the cable at suitable points.
8. Route the cable further in the cabinet to the upper side of the Active Line Module. When
doing so, route the cable in a similar manner to the standard cables that have already
been installed in the cabinet.
9. Use cable ties to secure the cable at suitable points.
10.Connect the signal cable at terminal block -X9.
11.Route the DRIVE-CLiQ cable through the cable bushing from the top into the Active Line
Module, continue to the DRIVE-CLiQ connection -X400, -X401, -X402 and connect there.
4.5.11.4

Cable routing for Motor Modules

For the Motor Modules in chassis format, the customer must carry out the following cabling
or connection work:
Table 4- 13
Cable routing
PROFIBUS cable or PROFINET cable to the Control Unit
DRIVE-CLiQ connections / signal cables to the Control Unit
Signal cables to the SMC10/20/30 Sensor Module (-B81/-B82/-B83)
Option K87, Terminal Module TM54F
Option K88, Safe Brake Adapter SBA 230 VAC
Cable connection between motor and Motor Module
Note:
The "Basic rules for cable routing" and "Preparatory steps" described above must
be observed whenever any cabling or connection work is performed!
106
Checklist for cable routing or connection work for Motor Modules
Completed?
Cabinet Modules liquid cooled
Manual, 10/2015, A5E37067587A