Fault/Status Messages - Pepperl+Fuchs IC-KP2-2HB21-2V1D Manual

IC-KP2-2HB21-2V1D
Commands
<SystemCode>
<T>
<TagType>
<Triggermode>
<WordAddr>
<WordNum>
<Year>
7.2.9

Fault/Status messages

Status
Error messages which triggered the identification system
Status
: = "U0" (high byte = 0x55, low byte = 0x30)
: 1 bit, toggle bit
: 2 ASCII characters, example: "02" for IPC02
: 8 bits
0 (00000000
b
1 (00000001
b
2 (00000010
b
: 2 bytes, word start address in the read/write tag, range from 0000h to
FFFF , depending on read/write tag type.
h
: 4 bits, number of words to be read or written, range from 0
depending on read/write tag type.
The following applies to IPC03: The word count 0h is used with the
word address 0000
("Default Read").
The following applies to IQC33: The word count parameter must be
even-numbered because of the block size of 8 bytes. The word address
then indicates the offset in 8-byte increments.
: 2 bytes ASCII, hexadecimal coding, 00
Meaning
00h The command has been executed without error.
FFh The command is processing.
Meaning
01h The battery of the read/write tag is weak.
02h Reserved
03h Reserved
04h Incorrect or incomplete command or parameter not in the valid
range.
05h No data carrier in the detection range.
06h Hardware error, e.g. error during self-test or R/W head defect.
07h Internal device error.
08h Reserved
09h The parameterized tag type is not compatible with the connected
reading head.
0Ah Several tags in the detection range (UHF).
0Bh Reserved
0Ch Reserved
0Dh Reserved
0Eh Internal buffer overflow.
0Fh Reserved
): trigger mode off
): trigger mode on
): trigger mode inverted
to read the preset data range on the read/write tag
h
h
to F ,
h h
... 63
h
77