Legend - Pepperl+Fuchs IC-KP2-2HB21-2V1D Manual

IC-KP2-2HB21-2V1D
Commands
IQH2-...:
IUH-...:
7.2.8

Legend

<ByteNum>
<Channel>
<ConfAddr>
<Data>
<F>
<Fill Sign>
<FixLen>
<FixType>
<IDCode>
<Identchannel>
<Month>
<P>
<ParamTyp>
<PSW>
<ReplyCounter>
<Sensorchannel> : Channel 1 or 2
<Status>
76
<SystemCode> = 'Q' ASCII (51
<ParamTyp> = 'K1' ASCII (4B
RP: liest den Schlüssel (12 Zeichen ASCII von 0 ... F)
im Transponder und im Lesekopf
WP: schreibt den Schlüssel (12 Zeichen ASCII von 0
... F) in den Lesekopf
Defaultschlussel = 'FF FF FF FF FF FF' ASCII
(46
Siehe Handbuch des Schreib-/Lesekopfes
: 4 bits, length of <IDCode>; 8 characters (08
: 3 bits, channel of the read/write head
Channel 1 (001 ), channel 2 (010
b
all channels (111 )
b
: 1 ASCII character, word starting address in configuration range of the
read/write tag. The following applies to IPC03:
01 = protection word
h
02 = control word
h
: <WordNum> times 4 bytes. When communicating a word,
the highest value byte is transferred first and the lowest
value byte last.
: 1 bit, multiplex mode, 0 (0
on
: 1 ASCII character
: 4 bits, length of the read only code in bytes, see "This command tells
the read/write head on the relevant channel which tag type to
communicate with. This setting is stored in the non-volatile memory on
the unit." on page 30
: 2 ASCII characters, example: "02" for IPC02
: 4 bytes, 6 bytes, or 8 bytes (depending on the tag type)
: 3 bits, channel of the read/write head
0(0000 ), 1 (001 ), 2 (010
b b
(but not <Sensorchannel> in trigger mode)
: 2 ASCII bytes, hexadecimal coding, 01
December)
: 1 bit, password mode, 0 (0
mode on
: Parameter type, 2 ASCII characters
: 4 bytes HEX, password
: 1 byte, increases by 1 after each response and confirmation. The reply
counter starts from 0 after the system is switched on. When the
maximum value is reached, the counter skips the value 0 (from 255 to
1).
: 1 byte (see chapter 7.2.9)
)
h
31 )
h h
46 46 46 46 46 46 46 46
h h h h h h h h
)
h
),
b
): operating mode off, 1 (1
b
), all channels (111
b
... 0C
h h
): operating mode off, 1 (1
b
46 46 46 )
h h h h
): operating mode
b
)
b
(01 = January, 0C =
h h
): operating
b