Mapd Task 3: Rebooting The Mapd; Procedure For Rebooting The Mapd - Avaya DEFINITY Manual

Setting up the MAPD Configuration
3. If a different host name from the default (definity) is desired, in the Host
Name: field, type the new name to be assigned to this MAPD system. The
machine name must be from 1 to 20 characters in length.
4. If an IP address other than the default (192.168.25.10) is desired, type the
new IP address in the Host IP Address field.
5. If a subnet mask is desired, type the subnet mask name in the Subnet
Mask field.
6. Press ENTER to save the changes.
7. Press CTRL-F 1 (EXIT) until you reach the Main Menu.

MAPD Task 3: Rebooting the MAPD

The objective of this task is to restart the MAPD operating system.

Procedure for Rebooting the MAPD

This procedure assumes that you have logged into the MAPD system and are at
the Main Menu (see
System" on page
Follow these steps to reboot the MAPD system.
1. From the Main Menu select 4. Maintenance .
The system displays the Maintenance menu.
2. From the Maintenance Menu, select, 3. Reset System .
The system displays the Maintenance, Reset System menu.
3. From the Maintenance, Reset System menu, select 2. Reboot System .
The system displays messages during the reboot.
If you reboot from the system console, the login prompt will appear when
the procedure is complete.
If you reboot from a remote connection, you have to reconnect later
(approximately 5 to 10 minutes).
3-12 Issue 3 May 2002
"Task 1: Basic Administration — Logging in to the MAPD
3-6.)