Komatsu PC400LC-5 Operation & Maintenance Manual page 151

18. OUTLINES OF SERVICE
18.1.4 GREASE
l Grease is used to prevent twisting and noise at the joints.
l The nipples not included in the maintenance section are nipples for overhaul, so they do not need
grease.
If any part becomes stiff after being used for long time, add grease.
l Always wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe
off the old grease in places. Where sand or dirt sticking in the grease would cause wear of the rotating
parts.
18.1.5 STORING OIL AND FUEL
l
Keep indoors to prevent any water, dirt, or other impurities from getting in.
l When keeping drum cans for a long period, put the drum on its side so that the filler port of the drum
can is at the side. (To prevent moisture from being sucked in)
If drum cans have to be stored outside, cover them with a waterproof sheet or take other measures
to protect them.
l
To prevent any change in quality during long-term storage, be sure to use in the order of first in -
first out (use the oldest oil or fuel first).
18.1.6 FILTERS
l Filters are extremely important safety parts. They prevent impurities in the fuel and air circuits from
entering important equipment and causing problems.
Replace all filters periodically. For details, see the Operation and Maintenance Manual.
However, when working in severe conditions, it is necessary to consider replacing the filters at
shorter intervals according to the oil and fuel (sulfur content) being used.
l
Never try to clean the filters (cartridge type) and use them again. Always replace with new filters.
l When replacing oil filters, check if any metal particles are stuck to the old filter. If any metal particles
are found, please contact your Komatsu distributor.
l
Do not open packs of spare filters until just before they are to be used.
l Always use Komatsu genuine filters.
3-7