12.15.2
INVERSION
1.
Place the bucket in contact with a flat surface.
REMARK
When
removing
the pins, place the bucket so that it is in light
contact with the ground.
If the bucket is lowered
strongly
to the ground,
the resistance
will
be increased
and it will be difficult
to remove
the pins.
2.
Remove the stopper
bolts and nuts, then remove
pins @ and @,
and remove
the bucket.
NOTICE
After
removing
the pins, make
sure that they do not become
contaminated
with
sand or mud and that the seals of bushing
on
both sides do not become
damaged.
3.
4.
5.
Install the bucket inversely.
After the bucket is inversed,
correct the inclination
and direction
of the retaining
pin holes @ and @ and stabilize
the bucket
securely.
Align the arm with holes @ and the link with holes 0, then coat
with grease and install pins @ and @.
Install the stopper
bolts and nuts for each pin, then grease the
pin.
Bucket cylinder
Link
2-71