Install the PowerGlide Plus Wiring
Wiring Connections
Note:
For wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006)
generously on both the male and female ends of the connectors. Application of the grease will
prevent corrosion to the pins and wires.
Install the AutoBoom Node
PowerGlide Plus AutoBoom Node Installed
FIGURE 12.
Mount the AutoBoom node (P/N 063-0130-010) to the machine's center rack within close proximity (3 feet/1
1.
meter) to the AutoBoom valve.
Note:
Position the node so that the cable connectors face down.
Insert the large, rectangular node connectors on the AutoBoom harness cable (P/N 115-0230-045) into the
2.
correct ports of the AutoBoom valve.
Tighten the bolt on the node connector to secure the connection.
3.
Connect the Harness - Newer Hydraulic Valves (Weatherpack
Connectors)
Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-045).
1.
Route the connectors to the AutoBoom valve (P/N 063-0131-124).
2.
Connect the left Press connector to Port G1 on the AutoBoom valve.
3.
Manual No. 016-0230-081
CAUTION
Always connect the power cable as the last
step in the wiring process and verify that the
power leads are connected with the correct
polarity. Reversing power leads can cause
severe damage to the equipment.
PowerGlide Plus
17