Table of Contents
Advertisement
CHAPTER
4
Install the Tractor Cables
The tractor cables are specific to the tractor being used to pull the planter. For available kits and ordering
information, contact your local Raven dealer.
Install the chassis cable's main battery connections, leaving room to provide access to the fuses in the
1.
cable.
Route the chassis cable to the back of the tractor.
2.
Connect the chassis cable to the cab cable.
3.
Extension Cable Connected to the Tractor Harness Cable
FIGURE 1.
Routed to the cab
cable connection
Routed to the
machine's battery
Route the cab cable into the cab and connect it to the Envizio Pro II.
4.
Install the OmniRow Harness Cables
Note:
On planters equipped with 16 or more planter row units, the harness cable is divided in half. The
left harness cable and right harness cable connect together at the middle of the planter. Locate the
cable connectors on each harness cable to determine which ends of the harness cables are
installed on the end row units of the planter. On planters equipped with 12 row units or less, the
harness cable is a single cable.
Manual No. 016-3001-004
W iring
C h a p t e r 4
Routed to the hitch
19
Advertisement
Table of Contents
