The code exists of a combination of 5 keys
(always the cursor keys and the OK key in
various combinations). E.g. 1, OK, 3, OK, 4.
One or more codes are shown for each
brand. Note the first code.
Be careful! There are separate tables for TV,
On our website www.philips.com/urc you can directly select your device
typenumber to find the right code.
Make sure you use the codes from the correct table.
Keep keys VOL + and PROG +
(5 and 6) on the SRU1060 pressed
simultaneously for three seconds until the
LED flashes twice and then remains lit.
Then enter the code noted in step 2
using the 1, 2, 3, 4 and OK keys.
The LED will now flash twice. If the LED
flashes once for an extended period, the
code has not been entered properly or the
wrong code has been entered.
Start again from step 2.
Point the SRU1060 at the TV and check that it responds as it should.
If the TV responds to all of the key commands, the SRU1060 is ready
for use. Do not forget to note your code.
If the device does not respond at all, or not to all of the key
commands, start again from step 2 and try the next code from