The SRU1060 now starts emitting all known . . . . . . . . . . . . . . . . . . . . . .
When your TV switches off (stand-by), release the TV (DVD) key of
the SRU1060 immediately.
The SRU1060 has now found a code that works on your TV.
Check if you can operate all functions on your TV with the SRU1060.
If this is not the case, you can redo the automatic setting.
The SRU1060 will then search for a code that works better.
After the SRU1060 has run through all the known codes, the search
will stop automatically and the LED stops flashing.
Automatic programming of a TV takes a maximum of 5 minutes.
For DVD this time is 2 minutes.
Manually setting the remote control
Example of TV:
The keys between brackets are used for setting the SRU1060 for your
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
Look up the code of your TV in the
code list at the back of this manual.
'TV off ' signals, one by one.
Each time a code is sent, the LED lights up.