Ricoh Pro C7200 Operating Instructions Manual page 63

Solution:
(a) Executing Fusing Belt Manual Smoothing Adjustment
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
select 0508: [Manually Smooth Fusing Belt], and then execute [Uneven Gloss: Short
Time].
2. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Repeat Steps 1 and 2.
3. To prevent this problem, adjust the values in print speed and fusing temperature. This will
decrease the throughput, but is it OK?
Yes Proceed to "(b) Adjusting the values in Print Speed and Fusing Temperature".
No Finished! If the problem recurs, try this solution again.
(b) Adjusting the values in Print Speed and Fusing Temperature
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then set the value in the following corresponding settings to [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
2. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 20°C.
• [BW/FC/FCS]
[Heat Roller Temp]
Streaks
61