Ricoh Pro C7200 Operating Instructions Manual page 124

7. Image Quality Problem: Full Page
No
10. Adjust the image density.
<If custom paper is used>
In [Advanced Settings] for the custom paper you are using, select 1201: [Max Image
Density], and then change all color values to [ ].
<If custom paper is not used>
In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0202: [Maximum Image Density], and then change all color values to [ ].
11. Print the image. Has the problem been resolved?
Yes
No
(b) Adjusting the paper transfer feed pressure
1. Register the paper in the custom paper profile.
2. In [Advanced Settings] for the custom paper you are using, set the value in 1222: [Paper
Transfer Nip Operation Mode] to [Low Pressure Mode].
3. Print the image. Has the problem been resolved?
Yes
No
4. Select 1223: [Paper Transfer Nip], and then set [Adjust Gap] to "4".
5. Print the image. Has the problem been resolved?
Yes
No
(c) Adjusting the paper transfer speed
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
decrease the value in [Transfer Timing Roller] by 0.1%.
2. Print the image. Has the problem been resolved?
Yes
122
Go to the next step.
Finished!
Proceed to "(b) Adjusting the paper transfer feed pressure" or "(c) Adjusting the
paper transfer speed".
Finished!
Go to the next step.
Finished!
Proceed to "(c) Adjusting the paper transfer speed" or "(d) Adjusting the
environment".
Finished!