Ricoh Pro C7200 Operating Instructions Manual page 51

This may occur if:
• Printing is done at low temperature or humidity
• Halftone images are printed in black and white
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Adjusting the value in Trans-Fusing Transfer Belt
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Trans-Fusing Transfer Belt]. Is it lower than -5.0%?
Yes Proceed to "(b) Adjusting the value in Fusing Belt ".
No Go to the next step.
2. Decrease the value in [Trans-Fusing Transfer Belt] by 0.5%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3.
(b) Adjusting the value in Fusing Belt
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Fusing Belt]. Is it higher than 2.5%?
Yes No further improvement is likely. Contact your service representative.
No Go to the next step.
2. Increase the value in [Fusing Belt] by 0.5%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3.
Streaks
49