If (J033/J034/J083) Appears - Ricoh Pro C7200 Operating Instructions Manual

8. Troubleshooting Paper Delivery Problems
6. Print the image. Has the problem been resolved?
Yes
No

If (J033/J034/J083) Appears

Cause:
If a solid fill image is printed, the paper may stick to the fusing belt when the paper is separated at the
fusing nip exit. This causes the paper to come into contact with the separation plate and is caught in the
fusing belt, resulting in a paper jam.
This may occur if:
• Printing solid fills
• Printing is done at high temperature
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Adjust the print speed setting
1. Decrease the line speed. This will decrease the throughput, but is it OK?
Yes
No
2. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then decrease the value in the following corresponding settings by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
218
Finished!
Contact your service representative.
Go to the next step.
Proceed to "(d) Decrease the heat roller temperature".