Ricoh Pro C7200 Operating Instructions Manual page 147

No Contact your service representative.
• Performing procedure "(e) Adjust maximum image density" increases the consumption of toner, and
it tends to decrease the fusing of toner. Perform this procedure as a temporary solution, and restore
the original set value after this printing job.
• For details about replacing the parts, see Replacement Guide.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
Worm Track
White wavy streaks appear if using a transparent film.
Cause:
This problem occurs when synthetic paper or transparent film becomes wavy because of the fusing heat
is high and the image comes into contact with the fusing belt.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Changing the printing speed
1. Decrease the line speed. This will decrease the throughput, but is it OK?
Yes Go to the next step.
No Proceed to "(d) Decreasing the fusing temperature".
DFP436
Uneven Density
145