Ricoh Pro C7200 Operating Instructions Manual page 312

9. Post-Processing Option Troubleshooting
• Paper curling
• Not stacked properly
• Paper jams
• Folded edges
Cause:
Curling may occur due to differences in the fusion and pressure application temperatures. Paper output
during post-processing may also fail to occur properly.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
If the decurler unit is used
1. In [Advanced Settings] for the custom paper you are using, select 1321: [Correct Paper
Curl], and then set [Correct Mode] to [U Curl Correction Level: Large] or [П Curl
Correction Level: Large] according to the curl.
2. Print the image. Has the problem been resolved?
Yes
No
3. Is the finisher shift tray selected to the output tray?
Yes
No
4. Select the finisher shift tray to the output tray.
5. Print the image. Has the problem been resolved?
Yes
No
310
Finished!
Go to the next step.
Proceed to Step 6.
Go to the next step.
Finished!
Go to the next step.