Ricoh Pro C7200 Operating Instructions Manual page 314

9. Post-Processing Option Troubleshooting
2. Select the finisher shift tray to the output tray.
3. Print the image. Has the problem been resolved?
Yes
No
4. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then decrease the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
5. Print 20 or more sheets. Is the condition of the image acceptable?
Yes
No
6. Is the toner fusibility within the permissible range?
Yes
No
7. Has the paper output improved?
Yes
No
312
Finished!
Go to the next step.
Go to the next step.
Contact your service representative.
Go to the next step.
Contact your service representative.
Finished!
Repeat Steps 4 to 7.
If the problem persists, contact your service representative.