Ricoh Pro C7200 Operating Instructions Manual page 180

7. Image Quality Problem: Full Page
No
3. Select 1212: [Image Transfer Output], and then increase the value in the following
corresponding settings.
• [BW]
[Black]
• [FC/FCS]
[Black]
4. Print the image. Has the problem been resolved?
Yes
No
5. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes
No
6. Select 1212: [Image Transfer Output], and then decrease the value in the following
corresponding settings until the problem is reduced sufficiently.
• [BW]
[Black]
• [FC/FCS]
[Black]
7. Proceed to "(c) Adjusting the maximum image density".
(b) Decreasing the image transfer output
1. Does any of the following problems occur?
• Drum imprint
• A black image is faint.
• Edge of an image is faint.
Yes
No
178
Proceed to "(b) Decreasing the image transfer output".
Go to the next step.
Repeat Step 1 to 4.
Go to the next step.
Finished!
Go to the next step.
Proceed to "(c) Adjusting the maximum image density".