Toner Scattering: Trailing Edge - Ricoh Pro C7200 Operating Instructions Manual

7. Image Quality Problem: Full Page
2. Print the image. Has the problem been resolved?
Yes
No
3. Set the value in 1222: [Paper Transfer Nip Operation Mode] to [Mode 4].
4. Print the image. Has the problem been resolved?
Yes
No
• After performing the solution, it is recommended to perform the color calibration of the external
controller.

Toner Scattering: Trailing Edge

Toner blasting occurs at a part of a line or character in an area between 8 and 13 mm (0.3 and 0.5
inches) from the trailing edge of the paper and the area approximately 20 mm (0.8 inches) from the left
edge.
8-13 mm (0.3-0.5 in.)
Cause:
During paper transfer, jitter is produced when the trailing edge of paper passes the paper feed guide,
resulting in blasting of part of the toner forming characters or lines.
This may occur if paper with a thickness equivalent to Paper Weight 4 or higher is used.
180
Finished!
Go to the next step.
Finished!
Contact your service representative.
20 mm (0.8 in.)
CNT009