Ricoh Pro C7200 Operating Instructions Manual page 105

No Contact your service representative.
White Spots: Like Bird Footprints
White spots like bird footprints appear at the trailing edge of the paper.
Cause:
This may occur if the transfer entrance guide plate is stained at low temperature and humidity.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. Increase the temperature of the machine's ambient environment.
Increase the temperature to approximately 20°C and humidity to approximately 30%.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Using a ruler, measure the length of the area with white spots (excluding the margin).
4. In [Advanced Settings] for the custom paper you are using, select 1101: [Image Position],
and then move the image closer to the trailing edge in the following setting according to
the measured length
<If white spots appear on Side 1>
[With Feed] of [Image Position: Side 1]
DXT846
Spots
103