Removing The Smartcard Reader - Fujitsu FUTRO S940 Operating Manual

System expansions

Removing the SmartCard reader

SmartCardreader
► Open the casing (see
► If a PCIe board or power supply is installed, remove the cross piece and PCIe board or power
supply (see "Removing the board", Page 47/"Remove power supply", Page
► Disconnect the cable from the SmartCard reader (1) and from the mainboard (2).
► Undo the screws (3).
► Lift the SmartCard reader from the carrier (4).
► When required, reinstall the cross piece and PCIe board or power supply (see
"Installing the board", Page 45/"Install power supply", Page
► Close the casing (see
Ensure that cables are not trapped between the casing and the components.
36
"Opening the casing", Page
2
"Closing the casing", Page
31).
3
4
1
49).
52).
50).
3
Fujitsu