Hpe Trusted Platform Module 2.0 Gen10 Option; Overview - HPE ProLiant BL460c Gen10 User Manual

9. Using a T-30 Torx screwdriver, fully tighten each heatsink nut in the order indicated on the heatsink
label (1 > 2 > 3 > 4) until it no longer turns.
10. Install the DIMM baffles on page 25.
11. Install the access panel on page 23.
12. Install the server blade on page 42.
13. Power up the server blade on page 21

HPE Trusted Platform Module 2.0 Gen10 option

Overview

Use these instructions to install and enable an HPE TPM 2.0 Gen10 Kit in a supported server blade. This
option is not supported on Gen9 and earlier server blades.
This procedure includes three sections:
1. Installing the Trusted Platform Module board.
2. Enabling the Trusted Platform Module.
3. Retaining the recovery key/password.
HPE TPM 2.0 installation is supported with specific operating system support such as Microsoft
Windows Server
product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs). For more
information about Microsoft
(http://www.microsoft.com).
CAUTION: If the TPM is removed from the original server blade and powered up on a different
server blade, data stored in the TPM including keys will be erased.
68 Hardware options installation
Front of Server
1
1
T30, 12 in-lbs
Must Install
1 2
3 4
Fully tighten
until screws
will not turn
Rear
®
2012 R2 and later. For more information about operating system support, see the
® ®
Windows BitLocker Drive Encryption feature, see the Microsoft website
3
3
Must Remove
2 1
4 3
Start
here
4 2
4 2
®